i had the wierdest experience today.
i wanted to change my memory on the pegasos2 allways used 512 mb.
so my buddy gave me some he had, 2x 512mb.

man this was gonna be cool or soo i thought.
pushed these suckers inside and booted.

Morphos as allways :D came and i started using it.
but then i tried starting OWB mos freezed. :/
rebooted tried again and the sec i click owb same result..
seems the hole system became unstable.

could anyone help with this?

http://en.wikipedia.org/wiki/File:Corsair_DDR_PC-3200_Memory_(Xytram).jpg

This is the ram i used.. i think i'll have to check inside peg to be sure.
post that later.

X

i *think* pegasos need PC2100 266MHz DDR ram, the ones you show picture of are PC3200 and 400MHz

Useing both sockets is not advised.
Useing RAM not tested for Pegasos is also not advised.

But .....

Sometimes the board won't get the wright settings after a RAM-change and you could try this:

Remove all RAM
Power on your Peg
Wait a while
Power down
Insert RAM
Try your luck

Run "memtext extensive" a few times, if it doesn't fail you stand a good chance of having a working system.