hi, does anyone here use any tablet with MorphOS? I bought a Genius EasyPen i608, and with MOS 2.5 it wasn't recognised, imo tablet is a great device for handwriting/drawing, and so it would be great to have a support for them... Can't be so difficult to write a driver :)

thanks and bye, MarK.

It doesn't even work as a mouse? Well, afaik there is at least special support for Wacom tablets:

http://www.platon42.de/poseidon.html

unfortunately no, i haven't tried it for several months, so i'll try it asap again...

bye, MarK.

Wacom was big for Amiga even leading up to 2000. They were supported AFTER Commodore went bankrupt. I wrote a big article on them and their products.
:-)

I got a cheap Trust TB-1100 tablet and it worked straight away (I just had to fiddle with Poseidon prefs a bit - to manually change the drawing area).

The problem of the poseidon HID driver is there not tool id support: so for all tabler it exists only one tool: a pen.
Bye bye brush, eraser, etc...

it's mainly due to input.device/intuition doesn't handle that also.

(except if you make your own driver)

Note: The i608 is not "EasyPen", it's a "MousePen".

[ Edited by Yomgui on 2010/12/16 14:25 ]

Mark: what are VID/DID of your tablet?

it's 0x5543:0x0005 ?